Вот как твоя панель снимается
http://arrc.epnet.com/autoapp/CHEVY_TRAIL_02-07_F2/CHEVY_TRAIL_02-07_CH06_Instrument_Panel_.htmСоветуую еще для прочтения:
http://www.chevy-clan.ru/forum/viewtopic.php?t=434To Remove: Remove the left closeout insulator panel from the instrument panel (I/P).
Remove the knee bolster trim panel from the instrument panel (I/P).
Remove the instrument panel cluster (IPC) bezel from the instrument panel (I/P).
Remove the retaining screws from the instrument panel cluster (IPC).
Pull the instrument panel cluster (IPC) out far enough to gain access to the instrument panel cluster (IPC) connector.
Disconnect the instrument panel cluster (IPC) connector.
To Install: Connect the instrument panel cluster (IPC) connector.
Place the instrument panel cluster (IPC) into the instrument panel.
Install the retaining screws into the instrument panel cluster (IPC). Torque the screws to 22 in-lb (2.5 Nm).
Install the instrument panel cluster (IPC) bezel into the instrument panel (I/P).
Install the knee bolster trim panel onto the instrument panel (I/P).
Install the left closeout insulator panel onto the instrument panel (I/P).
If a new instrument panel cluster (IPC) was installed, program the cluster.